Expect 1–2 days on most whole-house gas repipes in the Town of Loomis.
Up to half the price of a regular plumber, as your written Loomis quote will show.
Because we specialize in repipes, you get the work done quicker than a general plumber could, and it costs you less.
Half of Loomis homes date to 1980 or earlier, and the Town has a listed re-pipe permit. New gas piping goes from your meter to each appliance, while we submit to Town Hall and arrange the inspection.
Our visit shows us how your gas runs through the house. Afterward you have a written figure to think over.
Free, and your number won't end up on any spam list.
“Valentino led the work on our gas line installation. Travis made sure everything was pressure-tested and up to code. Great work and great attitudes.”
“PG&E shut off our gas due to a leak, and we ended up needing a full gas repipe. The crew handled everything — from pulling the permit to performing a full gas test and coordinating the inspection. The work passed without any issues and our gas was turned back on the same day.…”
“Santiago did an excellent job on our sewer and gas repipe. He was professional, knowledgeable, and communicated clearly throughout the entire project. The work was completed on time, the job site was kept clean, and the quality of the installation was outstanding.…”
What Homeowners Say
Local Facts
Loomis is a small town with a real share of older houses. Figures from Census ACS 2020-2024 show roughly 3,100 housing units, half of them from 1980 or earlier. One in four predates 1970, and another one in four arrived during the 1970s. By contrast, only about 14% has gone up this century, and 84% of local housing is detached single-family.
For a pre-1970 home that still has its original gas lines, that means more than 50 years in service. Those built in the 1970s are getting close to the same mark. The Census can only tell us about the building, not the pipe, so we start by looking at yours.
“Re-pipe” has its own line on the Building Division's mechanical and plumbing permit page, and it calls for a Building Permit Application plus a declaration about smoke and carbon monoxide alarms. Loomis names no online portal for this. Project submittals are sent digitally to bldgpermit@loomis.ca.gov, or a completed application can be turned in at Town Hall, 3665 Taylor Rd.
Town staff work Monday through Thursday and close to the public on Friday. Reach the Permit Technician at (916) 652-1840. Inspections run Mondays, Wednesdays and Thursdays, with morning or afternoon requests available. The Town lists a gas schematic for conversions from electric to gas; we check with the counter on what your replacement needs. All of this is our job, not yours.
Loomis Municipal Code 11.04.050 holds the Town's plumbing adoption: the 2025 California Plumbing Code with seven lettered appendices, under Ordinance 302 from December 9, 2025. We went through chapter 11.04 and saw no local amendment on gas piping. So you won't find a Loomis-specific CSST rule, and state code is what we follow when choosing materials.
Loomis sits on PG&E's Gas Service Territory list, grouped with its Placer County neighbors. If PG&E has found a problem and shut your service, its published guidance is that you should not turn the gas back on yourself. Someone qualified, either from the company or another professional, has to do a safety check first.
Sources: Census ACS 2020-2024 estimates for Loomis town; Loomis Building Division: Mechanical or Plumbing Permit; Answers from Loomis on obtaining a building permit; Town code chapter 11.04 (ecode360), including 11.04.050; Where PG&E supplies gas: Loomis listing; Leak and shutoff instructions on PG&E's safety site.
Whole-House Gas Repipe
We take the whole gas system out of the picture and put in a new one. That means all piping between meter and appliances, not patching one leak on an old line. Our crew pressure tests the finished work, and the Town's inspector reviews it under the permit we pulled.
With no Town amendment on gas, Loomis homes follow the 2025 California Plumbing Code, and that's what we install to.
Your range and furnace should have service again as the day wraps up on a regular repipe, but no house comes with a promise.
Tell us the utility shut you off. As soon as the repipe is done, we notify them so they can bring the gas back.
Our read of Loomis's chapter 11.04 turned up no earthquake valve requirement. If you want one regardless, it can go in with the repipe.
One thing before you read further. If there's a gas smell, PG&E's guidance tells you: “leave the area immediately,” then, once out, “call 9-1-1.” After that comes the utility, whose number is “1-800-743-5000.”
When to Consider It
Half of Loomis fits that description. Pipe that has stayed in place since the 1970s or earlier is getting up in years.
When the utility stops your gas over a leak, new piping plus Town approval gets you moving toward having it restored.
New appliances should get lines sized for their demand. Do it alongside a repipe and it all falls under a single permit. Going from electric to gas? The Town also asks for a gas schematic.
Cost
A Loomis quote comes after we've walked your house, free of charge. It's written, and it reflects these details:
A quick online figure is available from the gas repipe calculator, and financing details are here if you'd rather not pay all at once.
Our Process
We see your meter, your lines and your appliances, then give you a written quote.
We send the Building Permit Application and alarm declaration to the Building Division.
Every appliance gets a new connection. A pressure test follows, and most homes need 1–2 days total.
We request a slot on the Town's Monday, Wednesday or Thursday schedule. Gas is usually on by day's end on a regular job, too.
Common Questions
More in Loomis
Call today to set up your free estimate. We're a licensed and insured contractor, CSLB #1057926, and we'll give you the number in writing.
Licensed repipe specialists serving the Bay Area